The types of steps involved
Some types of staircases allow occupants of a dwelling to have an extra space used for storage. This space can also be used to develop an office area or alcove. Thus, the development is only possible for a straight staircase and turning. The operation is not suitable for other categories such as spiral as it leaves a very small space that can not be arranged to destinations above.
However, it is useful to remember that it is not only the sub-steps that can be used for storage. There are steps and risers for multi called "movable staircase". This concept is based on a model from Japan.
There are many things to consider regarding the use of the bottom of this equipment for storage and fixtures. This is the case of space dimension. Exploitable depth measuring between 70 and 80 m is required for adequate storage space.
For the arrangement to be preferred a straight staircase instead of the rotating model, lighting more suited to the location and unit colorsMaterials suitable for an ornament are also recommended.
What materials and tools used for development?
The development of a sub-steps do not require many materials and tools. They are, in general, the elements used in the context of the woodwork. These include, among other measurement tools such as square and the rule of one meter, the screwdriver, the cutter, pencil, and clamp the iron.
Materials that are most useful are:
- The laminates CTBH
- The bracket assembly
- The plate having a thickness of 5 mm for a coating of Assembled
- The ornamental moldings having a width of 26 mm dishes of interior finishes
- tiles using plastic facade
The development phase itself
Before carrying out the development, it is always advisable to establish a plan on paper. This will help to facilitate the assembly and installation of various pieces. Then who is tracing templates for cutting the slope of stairs in a box. Tracing lines on the boards with cardboard and the establishment of a roll of tape on the lines to prevent the outbreak of the laminate during cutting are to be made after that.
The next step is the rate in which there are cutting boards at a rate lowerTo adjust, use a jigsaw and a bracket fixed with clamps
The last three phases are:
- Drilling with screws
- The assembly of the coasts and shelves ends
- The finishing in which there is the installation of wheels and handle storage space |
