Preparatory phase
After delivery of the store and check the status of the package, proceed to unpack. The use of sharp objects is not recommended in this case to avoid a deterioration of the fabric. Afterwards, be sure to read the instruction manual to ensure that the various items necessary for the development of the latter are already present. After all this, there will be the installation of these objects on the ground in front of the place of his future position.
The position of these objects must be centered. The case of awnings, it is a distance measured at 10cm arm on the insideIf it has a length exceeding 4 m, there must be intermediate fasteners at regular. Be aware that setting these facilities should be made primarily wall or slab with a less complex inversion.
The installation can not be successful without a distance of 22 cm between the place where you put the opening and above the opening. Prior to installation of this equipment must ensure that the location affects the device for opening or closing windows and the current state of the walls.
Preparation of media
There are two choices to set up the blinds:
- Establish a direct them on opening the window
- the install on the wall or on top of the window frame
In the first case, to avoid the beating of them when the windows open and close, we need a bottom bracket or a guiding device attached to bottom side.
In the second case, one must take into account the decrease of the blind area in case of withdrawal. This system allows a full coating of carpentry.
The phase of the installation
An awning can be effective without a precisely centered position. Media, they must be set up on the principal amountWe must get help from another person to carry out this operation.
Here are some milestones of work:
- Nesting in the square tube posts
- Installation and clamping pins in them
- Conduct of the canvas with a crank
If it is a traditional window or door window, you must ensure that it does not reach the store in case of withdrawal. It is therefore necessary to establish it in a high location in order not to compromise the opening and closing windows. We must therefore measure the distance prior to the installation of the facility. |
