The need for installation
Before proceeding with the installation of the window, make sure to have the tools and follow the steps. Indeed, the materials are required to carry out its work, there is the crowbar that can serve as a lever and chisel, which is a metal tool. The mass which gives a better more effective strikes and the mini-hacksaw will be used for work adjustment. The masonry cement, and expanding foam plugs to seal and stability of the window and the drill are very convenient especially if it is a drill driver. It is also important to have a spirit level to work and one which is always useful cutteur.
The placement of a window is also a result of some preliminary steps. But first we must define the model to install because there are many to be the type leaf fixed structures to external or internal opening, the doors or tilt and swivel rocker not to mention the sliding window or skylight model. The type is the sole responsibility of the owner according to his needs and wishes. Once the model is defined, it should do the following: to the measurement of the opening for the manufacture of a suitable window in the space provided for it. Subsequently, there is the stage of acquisition of the window and the preparation of masonry, and only after that is the actual installation and finishing that completes the installation.
The steps of the installation
Before performing any task, you must first make the measurement for both the length for the height. This is a crucial step because it is these measures that will depend on the frame size that will support the window and then opening. After this step, it is possible to proceed with the installation of the frame after performing the steps. These include the introduction of wall anchors along a 60 cm spacing between each exposure and land use table must always be followed by a verification. For quality work, it must be very perpendicular and otherwise, it will hold the position of catching up.
Once these preparations made, it is possible to proceed to the installation of the window or door. To do this, proceed from the outside while placing the wall anchorsIt should be kept in place by pegs to cover the legs by the cement. Once the shell is complete, you can proceed to finish. This last step results in the placement of the finish coat for sealing. |
